IPV3 150 Watt Dual 18650 Sub Ohm Box Mod by Pioneer

*PLEASE USE 2x 30A BATTERY FOR THIS DEVICE*

 *The touch sensor on the iPV3 is not connected, and the included usb cable is for upgrading not charging the device.  The batteries must be removed to charge*

*150W can only be reached if you build your coils 0.33ohms or lower. This is due to the 7 Volt limit on the chip*

The iPV3 150 Watt Box mod by Pioneer4you is now available! This bad boy utilizes the Yihi SX330 V3 S 150W Chip.  The iPV3 is also going to have future chip upgrades for higher wattage as if you need more than 150 watts.  It features a sleek style and utilizes 2x 18650 30A Batteries.  Unlike the GI2 the IPV3 hits the moment you press the button with no ramp up.  It also fires from sleep mode without a second press of the button.  It is wider than the GI2 but much thinner.  It has 5 presets so you can set up your favorite wattages and recall them easily.  At a 7 volt max you can run much higher resistance than other box mods.

Physical Dimensions:

105mm x 59mm x 23mm

Technical Specs:

Includes:

1x iPV3 150 Watt Box Mod by Pioneer4You

1x USB Cable for Upgrading not Charging

1x Hex Screwdriver

2x Extra Hex Screws